![]() ![]() Pull a little on the core still hanging outside the line, trim with scissors, then tug on the eye to set the end back inside the core. ![]() To finish off the splice, work the cover back up the line until the exposed core with the cover inside pops back into the line. ![]() ![]() Pull on the end of the exposed core as you massage the junction of the core to cover the joint.ġ0. This creates a neat splice with a taper.ĩ. Starting about 4 inches from the end, use a small fid to pull out about 8–10 random strands from the cover before trimming them off with scissors. Work it down one complete fid length before pulling it out of the core.Ĩ. Now, wedge the end of the cover into the fid, then feed it into the core at the second mark. Make sure that both sections of core are not snagged on one another and freely move within the core.ħ. Pull about 6 inches of the core out of the hole. 15 / 25/35 with Eyelet.Double Braided Nylon Dock Line/Mooring Lines. Work the fid down so that it exits the cover 1 to 2 inches past where the core exits.Ħ. : Seachoice Double Braid Nylon Dock Line with Eye Splice, Pre-Shrunk, Heat Stabilized, Various Sizes and Colors : Sports & Outdoors. Wedge the end of the core into the hollow end of a fid that matches the diameter of the core, then push the fid into the cover at the first mark. That's where you will be inserting the cover into the core.ĥ. Mark the core where it comes out of the cover (your third mark), then pull out a couple feet more and place a fourth mark on the core two-thirds of a fid length from the one you just made. (If the end of the line was melted when it was originally cut to length, trim this off with a sharp knife so the core moves freely.) Lay the cord and the cover alongside each other.Ĥ. Using a small fid, separate the strands of the cover at the second mark and pull out the core. Form a loop or eye to the desired size then place a second mark opposite the first.ģ. Make a mark on the line one fid-length from the end.Ģ. Tie a slipknot about 15 feet from the end of the line, and loop it over a winch or cleat to hold it. 7/8″ diameter and up have short fid lengths calculated to approximately 25% of the total length of the full fid.1.9/16″ to 3/4″ diameter rope have short fids lengths calculated to approximately 30% of the total length of the full fid.Smaller ropes up to ½” inches in diameter, have short fid lengths calculated to 37.5% of the total length of the full fid.*Short fid lengths are often calculated as a percentage of the total full fid length as opposed to using 7 times the diameter or 1/3 the length of a full fid. The term “fid length”, in our splicing instructions, always refers to a “full fid length” which, is generally accepted to be 21 times a rope’s diameter.įor your convenience, the following table provides measurements for *short, long and full fid lengths.Īpproximate ratios – Short Fid* 1:7* – Half Fid 1:10.5 – Long Fid 1:14 – Full Fid 1:21 While they are often additionally used as measuring devices, the main purpose of a fid is to allow the user a means to manipulate the strands of a rope in order to complete a splice. Through the ages, fids have been made from bone, wood, plastic and steel in the form of wire, tubes and rods. Fids are one of the most important tools utilized in the splicing of rope. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |